Oxford_5oh
Active Member
- Thread starter
- #1
Hey guys,
Just had a dyno day to do some data logging to check everything is healthy on the pony.
During the 1st pull I learned they pulled fuse(s) and I'm more familiar with the route of just unplugging the plug by the air intake. So after the pull they put the fuse(s) back (didn't see if they pulled both the 50 and 5 amp) then we unplugged the pigtail for the remainder of the dyno session.
After we're done, I noticed the ABS light, traction control, air bag, etc were all still on but figured it needed to drive a couple miles to reset. The lights never went away so I've tried everything from swapping out fuses to unplugging and replugging the plug by the intake. I've reflashed my tune and nothing has worked to remove the lights and give me back the functions.
The only thing I can think of is the plug had a little piece of plastic on it that looked like a fastner to hold the plug to a body panel that broke off, didn't think anything of it. Any help?
Just had a dyno day to do some data logging to check everything is healthy on the pony.
During the 1st pull I learned they pulled fuse(s) and I'm more familiar with the route of just unplugging the plug by the air intake. So after the pull they put the fuse(s) back (didn't see if they pulled both the 50 and 5 amp) then we unplugged the pigtail for the remainder of the dyno session.
After we're done, I noticed the ABS light, traction control, air bag, etc were all still on but figured it needed to drive a couple miles to reset. The lights never went away so I've tried everything from swapping out fuses to unplugging and replugging the plug by the intake. I've reflashed my tune and nothing has worked to remove the lights and give me back the functions.
The only thing I can think of is the plug had a little piece of plastic on it that looked like a fastner to hold the plug to a body panel that broke off, didn't think anything of it. Any help?
Sponsored