wildcatgoal
@sirboom_photography
You basically have to drop it but I also shifted it back toward the rear of the car... a lot. It’s tough.
Sponsored
Probably could, just never got around to it.U could easily add shims with the car on ramps, not drop the sub frame again even?
I’m getting ready to do this, did you drill out the bushing insert from the front going towards the rear?Had some time earlier to put the 9/16" through bolts in the front mounts.
Dropped the cradle, drilled the bushings and that's all she wrote. Perfect fit and should work great.
I used a crows foot socket and torqued them to 130ftlbs.
Is it correct that the only way to install the front through bolts is by completely dropping the subframe?That was me - yes I did.
Ok, I was worried I’d have to pull the exhaust, drive shaft, brake lines, etc. just to drop the subframe far enough to drill out the bushings and get the bolt in.Correction. No jackstands. The rear was backed up on ramps. Lol