18' D1X Procharger first 1/4 times

[cnycomp]

Just ran my first full 1/4 mile runs today on the new setup. Best run was 10.62 @134 DA was 2360 it was a little over 80 degrees The car hooked up good out of the hole but I have a bigger problem when it shifts in to 2nd it breaks the tires loose. I stayed in it on the 10.62 pass but on one pass I had to let off as it felt like it was coming around on me. Im running 19" mickey thompson drag radials. I know I need a drag setup, that may be coming.

Setup is 18GT
10r80 auto
3.15s
Procharger D1X
Stage 2 intercooler
4.88 pulley
ID1050s
JMS Boostapump
Headers
Lund Tune
running on 93 with a can of boostane in each tank

Just thought I would give you guys some numbers if anyone is looking at a procharger setup

Sponsored

 

[2camsam]

Is this a auto or stick ? Also what was the 60 ft ?

 

[ypena02]

Which Mickey tire are you running?

 

[cnycomp]

forgot to add that in 10r80 auto
not sure what tire but its 325 19inch
60ft was 1.72 on both of my good runs

 

[bluebeastsrt]

Not a bad time for the summer heat. I had the same spin going into second issue. My tuner just dialed back the shift firmness. And problem solved. Do you happen to have a photo of how the 325s fit. I’m planning to switch from a 305/40r18. To a 325/35r18. And just want to see how they fit on the car. Any rubbing?

 

[Jmtoast]

forgot to add that in 10r80 auto
not sure what tire but its 325 19inch
60ft was 1.72 on both of my good runs

Assuming you're in drag mode?

 

[cnycomp]

Its a base model so no drag mode. Its Lund tuned , I just leave it in D

 

[Jmtoast]

Its a base model so no drag mode. Its Lund tuned , I just leave it in D

lol, that's awesome. Congrats on your build.

 

[Tommy V]

Thats not that bad for that heat and being on 93 us octane booster.I would put a 17 in drag tire and convertor in the car.With that in good air you should be close to 9's.Your mph should be a little better though with 4.88 on a d1x,but might not have alot of timing in it either for safety reasons.

 

[Confuzed]

What kind of pressure you run the m/ts? I have the mt ss 19” and consistently can pull 1.66-1.68 60 ft. Stone stock suspension on car. 22-24 psi in rear tires.
10.24@139 with 1.64 60ft on E85 in 2300-2500 da weather.
18 A10 car
Base with 3.15 gear.
D1x @11-12 psi
No cats.

 

[Tommy V]

What kind of pressure you run the m/ts? I have the mt ss 19” and consistently can pull 1.66-1.68 60 ft. Stone stock suspension on car. 22-24 psi in rear tires.
10.24@139 with 1.64 60ft on E85 in 2300-2500 da weather.
18 A10 car
Base with 3.15 gear.
D1x @11-12 psi
No cats.

I run the m/t ss in 305/45/17 at 18 psi and have pulled 1.40 and regular low 1.4' 60 ft times.This is an auto 315 gear d1sc.My car has been 9.7 at 143 but have not been.to.track.this season but once and broke my trans.Just rebuilt it.

 

[Confuzed]

I run the m/t ss in 305/45/17 at 18 psi and have pulled 1.40 and regular low 1.4' 60 ft times.This is an auto 315 gear d1sc.My car has been 9.7 at 143 but have not been.to.track.this season but once and broke my trans.Just rebuilt it.

What converter are you running?

 

[SolarFlare]

Good time. I think you'd benefit from a bigger sidewall. Make sure you heat up the tires well.

 

[cnycomp]

I had the tires at 18lbs. Yes I could use some 17s with more sidewall I agree!

 

[SolarFlare]

1-2 shift during burnout should put more heat in them and help you with that 2nd gear spin

Sponsored