No drill spoilers

[slowhand99]

Thinking of fitting one. The advantage is obvious, but so is the disadvantage. Anybody had any problems with no drill spoilers?

Sponsored

 

[hinch]

good tape and it holds on just fine at well beyond licence losing speeds mines been stuck on over 12 months now and its rock solid.

 

[Alfa Male]

Same here ultra lightweight carbon fibre spoiler fixed with quality tape along with panel prep, and it’s not going anywhere. In fact I’m more concerned that I won’t be able to get it off if I wanted to !

This is my spoiler that’s fixed with trim tape only.

 

[Adam83]

Previously had the track pack rear spoiler held on with 3M tape no problems and now have same as these guys above the carbon eBay spoiler and it hasn’t fallen off yet

 

[slowhand99]

Thanks for the replies, especially as I already bought the spoiler. Need some fresh IPA; the Greene King stuff didn’t work.

 

[s1ms]

Thanks for the replies, especially as I already bought the spoiler. Need some fresh IPA; the Greene King stuff didn’t work.

Will be looking forward to see it installed with pics along the way.

 

[Manders Mustang]

Mines been fine, peace of cake but it is an OEM replica part (that's meant to be drilled in but tapes held down fine)

 

[FilipV8]

Previously had the track pack rear spoiler held on with 3M tape no problems and now have same as these guys above the carbon eBay spoiler and it hasn’t fallen off yet

Do you like the new one more? Have you got side pictures of your car with both old and new? Which one of them is lower?
I cannot decide which one to buy so help would be appreciated

 

[Adam83]

Do you like the new one more? Have you got side pictures of your car with both old and new? Which one of them is lower?
I cannot decide which one to buy so help would be appreciated

Probably prefer the new one to the track pack item, I still fancy something bigger though!

 

[Symone]

Thinking of fitting one. The advantage is obvious, but so is the disadvantage. Anybody had any problems with no drill spoilers?

.
Think Roush go overkill with their fitting instructions don’t think I needed to drill and tape this down

Sponsored