Sponsored
ahl395
Well-Known Member
I have a Turbosmart Race port BOV. It still gives you the jet engine sound but much quieter than the Tial. A good compromise between the loud Tial and the quiet Proflow IMO
kcc0521
Well-Known Member
- Joined
- Feb 24, 2015
- Threads
- 231
- Messages
- 2,169
- Reaction score
- 303
- Location
- Falls Church VA
- First Name
- Bo
- Vehicle(s)
- 2015 Black GT PP
I run the BV57 on my paxton and it is not even noticeable under normal part throttle driving. Before that valve I had the stock vortech and it gave this annoying whistle and I tried the vortech race valve. The race valve was annoying as hell all the time.
Sponsored
kcc0521
Well-Known Member
- Joined
- Feb 24, 2015
- Threads
- 231
- Messages
- 2,169
- Reaction score
- 303
- Location
- Falls Church VA
- First Name
- Bo
- Vehicle(s)
- 2015 Black GT PP
That is a great BOV for anyone looking for a high flowing valve that is quiet at cruise.
Tommy V
Well-Known Member
- Joined
- Jul 24, 2014
- Threads
- 72
- Messages
- 3,653
- Reaction score
- 601
- Location
- Brookly park Md
- First Name
- Tommy
- Vehicle(s)
- 2015 race red gt pp manual, recaros, 401al DOA "too much boost on 93", 2017 GT Auto
Hey man i see u tied right where the hose for the stock proflow valve tied into.Did the tial valve slide right over the pipe or did u have to use some kind of adapter?If u used an adapter where did u get it,if u dont mind me asking?
Sponsored
Toy Cobra
Well-Known Member
- Thread starter
- #26
The mounting flang from TiAl is so large that the proflow pipe fit inside of it with about 1/8" clearance around it! We cut the proflow pipe off with a sawzall then used a grinder to open up the hole and welded the TiAl stand pipe in the same location. I tried fitting it in several locations but this is about the only place that it really fit.
Tommy V
Well-Known Member
- Joined
- Jul 24, 2014
- Threads
- 72
- Messages
- 3,653
- Reaction score
- 601
- Location
- Brookly park Md
- First Name
- Tommy
- Vehicle(s)
- 2015 race red gt pp manual, recaros, 401al DOA "too much boost on 93", 2017 GT Auto
Ok gotcha,i was hoping it was done with no fabrication but no luck.I do like how u did the install though.
Check06
Well-Known Member
Have the race red from Procharger myself. I had to cut part of the top of the radiator shroud to get it to fit right. The metal pipe it sits on before the intercooler is also a pain to fit in. I only wish the race red wasn't open all the time until it's boosting. My last Novi 2200 Mustang had a synapse on it and I only heard it flutter some when I would shift
Sponsored