GT350 CAI on 2018 GT?

[BigBlue]

Does the PP3 come with a new MAF sensor or is the factory one reused?

I believe MotoIQ said it comes with it.

https://motoiq.com/tested-ford-mustang-gt-power-packs-1-3/

Sponsored

 

[EVL-S550]

Looked into the part numbers for the MAF on the 18+ GT vs the Bullitt...they are the same. Might buy the intake assembly and have it tuned by Lund.

 

[Myshelby3425]

Looked into the part numbers for the MAF on the 18+ GT vs the Bullitt...they are the same. Might buy the intake assembly and have it tuned by Lund.

Do it! Been wanting to see how these compare with the rest. The Bullitt intake creates a perfect seal with the hood unlike the rest so it wouldn’t be taking in hot air from the engine bay.

 

[EVL-S550]

Do it! Been wanting to see how these compare with the rest. The Bullitt intake creates a perfect seal with the hood unlike the rest so it wouldn’t be taking in hot air from the engine bay.

Only thing I'm uncertain on is if the Throttle Body is different on the Bullitt? Hoping the intake tubing can just connect right up to my GT TB.

 

[drive_55_not]

Only thing I'm uncertain on is if the Throttle Body is different on the Bullitt? Hoping the intake tubing can just connect right up to my GT TB.

The Bullitt uses the GT350 intake and throttle body.

.

 

[EVL-S550]

The Bullitt uses the GT350 intake and throttle body.

.

Trying to figure out if I can simply buy the airbox and filter or if I could somehow get the tube to fit up to the 80mm TB on the GT.

 

[michail71]

What about getting the GT350 TB with the adapter? The GT 350 TBs aren't too expensive but I'm not sure if there is any benefit either.

 

[michail71]

I've wondered about the open CAI's on the Mustangs in general. The last open CAI I had on an Audi would get dirty from the hood lining and eventually pulled it off the hood (after a few years). I wound up removing the hood liner.

Sponsored