2018 Mustang GT Knock sensor location.

[Bullett]

I just wrapped up on the install of my whipple on my 18 gt. I got some knock sensor circuit codes and I honestly don’t recall unplugging them. This however made me doubt that maybe the location on them isn’t where the other coyote cars were. Does anyone have a photo of where they’re located in the 18’s?

Sponsored

 

[M151A2]

Not a lot of light down there to see but it looks like there might be 4 of them. My 16 has two.
At least I see 4 wires.

 

[Bullett]

Yes that’s what I thought as well, but I’m doubting myself lol

 

[Tommy V]

On the 15 to 17 models didnt u have to do something with the knock.sensors that required u to have to retorque them?

 

[superman07]

typically you must seperate them from shielding a bit and move them out of the way. If you didnt you might have pinched a wire.

 

[engineermike]

You don’t have to adjust the sensors or move the wiring on the 2018.

 

[Bullett]

That’s what I’m starting to think. To be honest we didn’t touch them at all from what I recall. If we have to move them a bit, we for sure didn’t

 

[Bullett]

So then I probably pinched a wire or something of that nature.

 

[Bullett]

Looks good

 

[Bullett]

Main harness

 

[BlueCollarDaily]

What did you end up finding?

 

[Bullett]

Pinched wire I’m assuming. Removed blower to inspect, didn’t see anything, put back on and was fine lol. Gone 9.1’s and 155’s since

 

[BlueCollarDaily]

Sigh I fear the same issue with EB thanks for updating thread...nothing was unplugged you simply remove looked and reinstalled?
Thanks

 

[Bullett]

Yup!

 

[Luv2gofst666]

I just finished my install and I think I’m having the same issue... pinched wire

Sponsored