Edelbrock 2018-2019 Mustang Modular Inlet 2650 TVS Supercharger – Stage 1 - 15832 & 158320

[Edelbrock Tech]

what price range is the 103mm Throttle Body going to be in?

It will be similar to what other billet aluminum 103mm drive by wire throttle bodies cost.

Sponsored

 

[08fordgt]

I want one!

 

[ICEFURY]

Sure would love to see a Whipple vs Edelbrock comprehensive comparison. For all the people on the fence between which way to go.

 

[Kona 18]

Sure would love to see a Whipple vs Edelbrock comprehensive comparison. For all the people on the fence between which way to go.

From what what i've gathered in this thread, the whipple will pull ahead due to it's size and 132mm/150mm TB, they have practically no pressure drop across them so the rotors have access to ambient pressure, which means more power. The Edelbrock with the 103mm will be a good TVS 2650 option though, performs better than the Roush purely on the fact that they have a blower plenum thats much larger and they will have a inlet to allow for larger TBs.

If the goal is to stay in the 700-750whp range though, I think they will both get the job done.

 

[Edelbrock Tech]

From what what i've gathered in this thread, the whipple will pull ahead due to it's size and 132mm/150mm TB, they have practically no pressure drop across them so the rotors have access to ambient pressure, which means more power. The Edelbrock with the 103mm will be a good TVS 2650 option though, performs better than the Roush purely on the fact that they have a blower plenum thats much larger and they will have a inlet to allow for larger TBs.

If the goal is to stay in the 700-750whp range though, I think they will both get the job done.

We were able to make over 750whp with a stock throttle body and some octane.

 

[Dalton@Evolution]

We were able to make over 750whp with a stock throttle body and some octane.

eyes closed

 

[sdiver68]

Retain tower brace?

 

[Edelbrock Tech]

Retain tower brace?

The factory strut tower brace will not fit over the supercharger.

 

[ShelbyGT350]

To our Edelbrock Tech, have you seen any aftermarket (or custom-made) strut tower braces that WILL fit over your supercharger?

 

[Edelbrock Tech]

To our Edelbrock Tech, have you seen any aftermarket (or custom-made) strut tower braces that WILL fit over your supercharger?

Nothing that I am aware of. The hoods on these cars are just so low.

 

[ShelbyGT350]

OK. Looks like we also lost at the right side cowl brace - correct?

 

[sdiver68]

The factory strut tower brace will not fit over the supercharger.

Ok thank you and darn. With a PP1 Vert I just dont feel like I can lose that brace.

 

[Mustang_Lou]

Ok thank you and darn. With a PP1 Vert I just dont feel like I can lose that brace.

A stiffer front anti-roll bar may be the ticket then if they make one for the 'vert.

 

[08fordgt]

ive seen strut tower braces fit over the whipple kit. so anything is possible.

 

[West TX GT]

Just get BMR 4 point chassis brace. Problem solved

Sponsored