Side_Pce
Well-Known Member
- Thread starter
- #1
Just wanted to make a quick post about my Transmission cooler install.
Parts I used:
Weldon Racing 9200 pump
OEM Cooler
OEM forward lines
Earls hardline to AN fitting
Aeroquip (2) -8AN straight push lock
Aeroquip (2) -8AN 45 push lock
Aeroquip (2) -8AN 90 push lock
Aeromotive (2) 1/2 NPT to -8AN
Aeroquip socketless AQP lines 15' (used 10')
Aeroquip line hangers
(2) hose separators
Hose mount bracket (used an L bracket, mounted under transmission using existing threaded holes.)
Painless performance Relay kit
Dorman rocket switch (LED)
Dephi weatherpack connecter (+ crimper)
Various wiring parts, tools.
Hose cutter
Bolts, nuts, washers.
Fabricated mount for the pump. (I used (2) 5"x1"x1/8" stainless plates, drilled holes and tapped threads in one side to sandwich the pump T-Clamp onto the lower engine frame, right under the front sway bar. It was the only location I could find that limited the amount of line used and still be in the location of where the forward line ends. It wasn't the first place I wanted to mount it, but I didn't have the tools to make one.)
Amsoil ATF fluid
This is about all I can think of for parts.
I made a short video here. #### ####
Parts I used:
Weldon Racing 9200 pump
OEM Cooler
OEM forward lines
Earls hardline to AN fitting
Aeroquip (2) -8AN straight push lock
Aeroquip (2) -8AN 45 push lock
Aeroquip (2) -8AN 90 push lock
Aeromotive (2) 1/2 NPT to -8AN
Aeroquip socketless AQP lines 15' (used 10')
Aeroquip line hangers
(2) hose separators
Hose mount bracket (used an L bracket, mounted under transmission using existing threaded holes.)
Painless performance Relay kit
Dorman rocket switch (LED)
Dephi weatherpack connecter (+ crimper)
Various wiring parts, tools.
Hose cutter
Bolts, nuts, washers.
Fabricated mount for the pump. (I used (2) 5"x1"x1/8" stainless plates, drilled holes and tapped threads in one side to sandwich the pump T-Clamp onto the lower engine frame, right under the front sway bar. It was the only location I could find that limited the amount of line used and still be in the location of where the forward line ends. It wasn't the first place I wanted to mount it, but I didn't have the tools to make one.)
Amsoil ATF fluid
This is about all I can think of for parts.
I made a short video here. #### ####
Sponsored
Last edited: