brandonsmash
SMASH!
- Joined
- Aug 19, 2015
- Threads
- 58
- Messages
- 1,304
- Reaction score
- 340
- Location
- Phoenix, AZ, USA
- Vehicle(s)
- 2015 GT - PP
- Thread starter
- #1
Commbubba19 had a Flowmaster exhaust he was literally giving away. Seriously. Apparently the PO had cut it and used hose clamps to seal the cut imperfectly.
In any case, Commbubba19 sent the exhaust to me for the cost of shipping. I'm in the process of TIG welding it back together (if you're a welding nerd like me, Flowmaster uses 1/16" 409 stainless; I'm using DCEN at ~85 amps, 1/16" 2% thoriated tungsten with 1/16" ER309LSi) and I plan on running this on my GT when it's done.
Shipment was very reasonable, fast, and there was tons of communication. Absolutely zero issues, and I'm chuffed about the whole thing!
Huge thanks and recommendations to this member, who is very much an asset to the community!
In any case, Commbubba19 sent the exhaust to me for the cost of shipping. I'm in the process of TIG welding it back together (if you're a welding nerd like me, Flowmaster uses 1/16" 409 stainless; I'm using DCEN at ~85 amps, 1/16" 2% thoriated tungsten with 1/16" ER309LSi) and I plan on running this on my GT when it's done.
Shipment was very reasonable, fast, and there was tons of communication. Absolutely zero issues, and I'm chuffed about the whole thing!
Huge thanks and recommendations to this member, who is very much an asset to the community!
Sponsored