DIB PP build

[Toowired]

I added some carbon fiber to the car, replaced the little mirror triangles and added mirror covers.


I also bought a carbon fiber blackout panel for the rear. I didn't mind the panel being wrapped, but it was a flat color instead of shiny like the rest of the car.




On the way are Carbon fiber hood vents, Nitto NT05 305/35/19 rear tires, and the Airlift digital system.

Sponsored

 

[pumxee]

Message to the OP. Did you install the ambient light kit yourself? How did you wire it in? Don't need to know about the other stuff just getting the wiring to a power source

 

[Toowired]

Here is a copy of the wiring from the installation information.

 

[pumxee]

Here is a copy of the wiring from the installation information.

Where is this unit located in the vehicle?

 

[Toowired]

Behind the passenger side kick panel.

 

[Toowired]

I ordered Nitto NT05 305/35/19 from discounttiredirect and had them mounted to my PP 9.5 inch wide wheels. They truly are amazing looking. The sidewall cuts out just a smidge (about as much as the Pirelli 275/40/19 cut in). I wanted to buy the American muscle 10 wide wheels, but I am very happy with how these tires look on the 9.5 wheel.

 

[Toowired]

I installed the Airlift system over the past week as well as added jacking rails and the front K member brace from Steeda.


Here is a link to the video of the car going down.
http://s150.photobucket.com/user/me...Uploads/XiaoYing_Video_1457046794958.mp4.html

Sponsored