I got a trailer hitch and one of these....
https://www.rightontrailer.com/
I've actually converted the trailer to a flatbed to haul my autocross tires, but I can unbolt the plywood and put J racks back on.
I had the same problem. I had to take it in a couple times, but they finally figured out it was the vent tube, dropped the transmission to replace it, and it's been 100% fine ever since. No problems at all from the tranny drop.
I had checked my spindle nuts and they were tight. But I had play in the wheel when jacked and the creaking noise.
Just picked the car up from the dealer yesterday after they replaced the hub, and the sound is gone.
My 2016 GT PP is making that same noise. I knew I had a bad wheel bearing and brought it in to the dealer last week. They confirmed the bad bearing and that was what was causing the noise. Now awaiting the part to arrive....
Mine is creaking, even after I checked the nut (took about 1/4 turn to get to 150 ft-lbs).
I know my bearing is going - I can wobble the wheel a bit when it's off the ground. Haven't brought it in yet....
I had the same problem, but on the driver side. See this thread:
http://www.mustang6g.com/forums/showthread.php?t=81846
Replacing the stud with a bolt works fine...
It was pretty good. The weather didn't cooperate the whole time, so driving wasn't too amazing. Plus, the GF was fighting a migraine so the newly upgraded stereo stayed off the entire time, and my driving was pretty tame...
I would love to go back to the Helen area and open her up a bit more...