Recent content by TEXAS HEAT

Yes sir, still available. My apologies for the delayed response.

Bump

Calling All 2015-2017 Mustang GT's - FOR SALE: 2018-23 Ford Mustang GT Stock Air Box and Inlet Hose with AFE Dry-Flo Replacement Filter If you you own a 2015-17 Mustang GT 5.0 and you're looking for a great bang for the buck upgrade, I have a deal for you! This intake will perform as well as...

Replied sir.

For Sale - Used S550 Mustang Miscellaneous Parts ‐ PayPal only, prefer local to Houston, however willing to ship at buyer's expense. Stock Replacement Green Air filter - $25 SOLD 2x stock fuel rails, one modified for CJ Intake ‐ $40ea. Weather tech front floor mats - $50 SOLD JLT 3.0 Oil Catch...

@engineermike The Jones resonated muffler is a dual 3" tru-x and does not neck down once inside the case. I think I posted images of mine, and it is clearly designed an x-pipe

Sorry about the misinformation, The G2 is 3.5" and G3 is 3.75" I have the G2 and though it was .5" smaller inlet than the G3. I'm glad you figured it out though.

4.0"

Here's a snip of my most recent data log on my 2019 GT ESS G2 125mm Pulley with stock fuel pump, BAP, FIC 1000 and VMP Fuel Rails on E-Free 92 with 3oz Boostane. The sample rate on the Lund NGuage is .07 seconds per line. As you can see, the lift pump pressure occasionally dips down to under...

Now that the exhaust is a full 3" all the way back with the Jones resonated X, the most noticeable difference for me was the absence of the nauseating low frequency drone of the Borla 60661 at cruising speeds (1800-2000rpm) I have the Jones 3" X mated to the Borla 3" S-Type and the exhaust is...

Please share your virtual dyno vehicle set up. I haven't had any success converting data-logs with the my Gen3 in the software. Did they update the it recently?

What size vacuum hose are you using to connect to the FPR? Does it step down before going into the boost reference nipple?

Pulling wet air across the MAF sensor will actually cause it to read incorrectly and will potentially damage it. I ended up replacing mine because it got wet and it would intermittently go into limp mode. I recommend buying a new MAF sensor which should resolve your issue. You can try cleaning...

2oz per gallon of 93 octane, correct?

The Borla 60661 is the same one that I replaced with the Jones Tru-X. The sound is much better imo and it doesn't leak from the crappy factory connects. Does it make more power now...? probably not, but there's no longer any restriction.