My 2018 GT PP1 went back to stock. Lots of good stuff for sale. Less that 3k miles on all parts. You pay all PayPal fees. Parts are in Las Vegas Area. I will make you a better deal if you pick stuff up. All prices are more than fair, don't waste my time with low ball offers.
Cervinis C...
My 2018 GT PP1 went back to stock. Lots of good stuff for sale. Less that 3k miles on all parts. You pay all PayPal fees. Parts are in Las Vegas Area. I will make you a better deal if you pick stuff up. All prices are more than fair, don't waste my time with low ball offers.
Steeda 1.5"...
I converted mine, and have been driving with it for about 3 weeks now. I bought the mufflers from the dealer, and painted the tips w/ flat black header paint. On my car (400A - PP1 - Mangeride), there is already a connector that is part of the main harness. The connector is in the middle of...
When the active exhaust is in track mode, all of the exhaust is routed through the innermost tip, essentially bypassing most of the muffler. The outer tip is only used when the valve is at least partially closed.
I am not sure on the diameter, but my front is sitting on the garage floor. I changed out the front to a 1-3/8" steeda. Make sure you do the end links, my stock ones were bent with the stock PP bar. I am putting on the BMR ones this week. The car tended to oversteer a lot with the stock bar...
I have the mufflers in my possession, I paid $188 ea. I did some investigating on my '18 GT. There is the connector shown in the pictures at the rear on the car, plugged into a blank to keep it clean.
The relay & fuse are also present in the relay center.
It looks like the only other thing I...
Are you familiar with Arduino? I have ordered the mufflers from my local dealer. They should be here early next week. I plan to wire them to the factory ppm, and enable using for scan. What I would like to do is wire a switch and have the valves be RPM controlled @ 3000 RPM. What would I...
I swapped out the 3.5" door & center speakers for Polk DB351's. The bracket that holds the door speaker needs to be modified a little, but its easy with a dremel. I unplugged the A-pillar tweeters, with the addition of the door tweeters, it was too much and they are not aimed at the driver at...
What I did when I changed mine is loosen the plug, and partially pull it out, but not remove it totally. It will take a little longer to drain, but you can control the flow and keep your garage floor clean.