Recent content by Silver550

did anyone ever figure out the sub box angle against the rear seat?

I want to get a new sub box designed for my mustang and I wanted to know if anyone with a Zenclosure could send me the measurements? I am specifically looking for the angle that rests against the rear seats. I wanted to try and purchase a sub box design for a 4th or 6th order bandpass box that...

Would this fuel system support 800 whp with id1050’s on e85? I’ve been reading around and it seems that people are starting to upgrade or move on from this kit. I was wondering why that is?

You should try the magnaflow resonated x pipe with your current setup. The headers is what makes it super loud. I also had Lund revise my tune to tame my cold starts.

@RUBY RED 550 what other exhaust mods do you have? I’m out since I have a single tip setup. But I’m just curious about your mods. You would want to stay away from Roush, Corsa Sport, Borla attak, and MBRP Race

Is it the touring axle back or the straight pipe louder axle back?

I have a question for you guys. Ok, I’m going to be using the RF DSR1 and I’m going to hook up the front 3 door speakers only and the sub. What amp settings should I put on the amps for the fronts? I’m thinking of leaving it at full range because I’m going to be using the DSR1 for crossover. Or...

ok, couple more q's! Thanks for everyone who has been helping out, I really appreciate it. 1. from my understanding if you run a a dsp, you have to run your speakers active, meaning no component crossovers and each speaker to its own ch. for example I purchased the RF DSR1, and noticed that...

Thanks @CrashOverride! I think I’m just going to buy a DSP. Would I still need to get rid of the oem dsp?

oops I accidentally posted in another thread, I think this one is the right place. Hello, I was going to install a speakers and sub a while ago but things kept coming up. I am now ready to do the install, I just have a couple of questions. 1. would it be ok to not run a dsp after deleting the...

Hello, I was going to install a speakers and sub a while ago but things kept coming up. I am now ready to do the install, I just have a couple of questions. 1. would it be ok to not run a dsp after deleting the stock dsp via ForScan? 2. what speakers should i run the sub signal from, (front/...

i'm assuming that its a dual 2 ohm?

you willing to ship to SD?

To piggy back off of OP, I too would like to know the specs. I need a box similar to the Zen box but eith more volume. I would like to know the specs of the zen box. The height and width and both depths if possible from a dual sub setup.

OP, you bought a sct tuner and you are running the canned tunes? If so you now need to buy a tune from Lund or anyone else now. They are way better than the canned tunes.