Recent content by randy_tho

What set did you go with? Ive been looking at these for a while.

Ive got the Steeda IRS braces but I think the CB does something similar and stabilizes the deflection of the IRS subframe with all of its rubber isolation. Best I could describe is it provides some stability and less "floatiness" under acceleration and some turning situations.

It was a joke. Look at the picture in the quote. I've got the m600 19x10 on my performance pack car.

I have a similar noise but I notice it more when the rear suspension articulates. I checked and replaced axle nut on driver side. My car is low mileage and if I drive in the rain some the noise will go away so I suspect its some of the rubber on the IRS. I got a similar noise from my 08 GT from...

Can anyone confirm they clear the factory brembos without spacers....?

My first thought would be some of that felt tape stuff. Ford used it a lot on the S197 to cut rattles. If you can put it on the bezel where it is not visible it may wedge it enough to relieve the issue. (Given the cluster is otherwise secure and doesn't eventually shake apart.)

Possibly check at the top middle front of the clear plastic. From pictures these tend to vibrate there and it causes some marring. Maybe that is the source of the noise.

Maybe you got some kind of test message by accident?

Added to my above post. Any idea if something like that? Have you jailbroke it or anything?

OP, iphone or Android? There are some techniques using a screen overlay to impersonate an app on a compromised device. https://blog.malwarebytes.com/cybercrime/2017/10/a-new-kind-of-apple-phishing-scam/ During the message you can kind of play with the task switcher to get a feel if that is...

Most of these mods can be done cross model when the hardware is the same but the as built software has been tailored/configured a certain way. Then that can be changed to "unlock" the feature. My guess is the cluster is different so its not going to be common enough. Plus the sync system is...

Is that a thing on the factory installed package?

I have a black ashiko and we have had several days around 90. It is not bad but I don't have a vert. Especially after the AC runs about 30 seconds. My 08 with the premium interior package had an aluminum one that was insane. It'd leave the shift pattern in your hand.

Anyone got pictures of the black scott drake ebrake handle installed? I think it has machined stripes on the top of it. https://www.drakeautomotivegroup.com/15-blk-billet-park-brake-cover-fr3z-2760-blk I'm about to install some red stitched leather on the brake, shift boot, and console lid...

?? With the 10.2 it just works. No extra parts needed.