Recent content by Outlaw

Doeends what's closest. Me personally I love husky. It's the same factory as gearwrench but husky tools are home depot so you walk in and walk out with a replacement if they ever break or have any issues. All hand tools have a lifetime warranty even rubber mallets, chew one up beating parts off...

So if damage is still there/would require it to be redone it's effectively the same as the paint being damaged since it would also need redone. This is all very good info to have and given what it is (a daily driver that I drive HARD and in all weather and road conditions) I think I just have to...

Does this apply to vinyl wrap to? If so given the hood already has a chip and it will be a daily driver again I might aswell just leave it. At most of ceramic coat it for 1k or so just to make washing it easier but even then maybe not. Might still do pdr to remove some roof and trunk dents and...

I just don't have the time or desire to do it. It would also be done on the street which I don't want to it

Does it hurt it to not push it fully? I always push it fully to try and reduce wear. Ive got BG fluids and a mfw shifter with a real heavy billetworkz knob. Even shifting at 8k (yeah ik, trying to prevent wear but holding the motor at 8k max redline ripping down the highway for like 15-30...

Did this help with the engagement point? I have a 17 and the engange is like the last inch. So much so that I'll think I'm still like 80% in the slipping zone and go to let finish letting it out just to realize my foot was just touching it and it was fully released. Doesent take much of a touch...

So in-between accidents alot of my mustang is being painted, everything except for the back end and roof of the car and passenger quarter, everything else looks great. Came out to find a chip on my fresh hood and was disappointed. I'm pretty much broke but I don't plan to sell this car, 2017 gt...

You can run sync 3.4 force installed. I did a sync 3 upgrade in my 17 (same exact stuff as 2015) all in about 600$ and 250 was for a harness because I was to lazy to make my own harness but making your own saves alot of money

Depending on insurance they usually do free replacements

Do you 3d print these/ make them or resell? Id be extremely interested if it was possible to have them printed to match custom car grilles or printed without anything in the opening, these are my oem grilles modified with custom car grills mesh I'd like to match.

It's right next to the 10mm socket

Could closing the door by the window have caused this? I normally close it by pushing the door and not the window but it's been pushed in the window a few times?

Yeah, closest station is like 40 mins away which makes it way to cumbersome to be worth it and other stations are spread out even further so any travel would be severely limited. Currently tuned by Shaun at AED but I know Wengerd is also top notch

Must be nice to have e85 local to you, I want to get tuned for it so bad but I'd have to have all my fuel shipped to me which could end poorly

So I noticed today while opening the door to film a video for insurance that my window is floppy. I'm not sure if it's a car fault or maybe a shop thing? The quarter panel was repainted but the door panel was not removed to my knowledge but could have been. I noticed it's got significant play in...