Sponsored

Recent content by mt82#1fan

  1. Hold out for PP2 or buy PP1 -> Track Build

    If you go PP1 go 2020+ to get all of the S550 tweaks including the better version of the mt82 transmission. I've tracked mine and never had an issue with overheating even in July in Texas @ COTA.
  2. Should I build my MT82 or go automatic?

    link to direct oem replacement?
  3. Update on Scored Cylinders

    Is the intake system stock? Have you tightened all of the connectors / clamps between the filter and the throttle body? I had a P0300 on the track that turned out to be the engine flexing on the motor mounts under heavy braking that was kinking the intake hose and letting in un-metered air and...
  4. 2017 GT self auto-enabled rev match after swapping a tr-3160... need help for disabling it....

    Have you seen this thread? If you didn't reprogram the gear ratios that could be an issue but this is only a guess https://www.mustang6g.com/forums/threads/tremec-3160-swap-in-a-18-gt-base.187942/#post-3905382
  5. Final Attempt - Misfire Issue

    Have you checked all of the clamps for the intake and cleaned the MAF sensor? I had similar code pop up at the track under heavy braking and it turned out under deceleration the intake tubing would compress as the motor rocked forward allowing a gap in the intake for un-metered air to get in and...
  6. What are the cons Sport Cup 2 tires in a 2018 GT PP1

    Why not pick up some Michelin Pilot Sport 4s? Better treadwear (last longer), great performance for the street and cheaper.
  7. Rear brake squeal - even after new pads+rotors

    Ford dealership service departments are notoriously horrible so I'd recommend finding a local mechanic you trust nearby moving forward. It sounds like you have a couple of things that need checking. The rear brakes require you to reset them when changing the brakes and this is a common oversight...
  8. Headed back to the 1/4 mile, tell me if I am missing anything.

    What's your plan if you snap your axles? I'd probably consider swapping in GT350 axles for insurance and I'd also buy some new drag radials to fully enjoy the next session. Good luck.
  9. SHOW ME YOUR WHEELS 19s only

    Gorgeous setup - are you running extended studs up front? What camber front & rear? What camber plates? Do you wish you were on a 35 series tire?
  10. CHECK ENGINE LIGHT codes p0308 and p061a

    Likely loose vacuum hose or intake elbow. Check intake from filter to manifold and tighten everything then clear and see if it recurs.
  11. My CarMax GT350 purchase experience

    Did you buy the Carmax extended warranty?
  12. 10r80 Tuning & P061A

    P061A is tire size or vacuum leaks in the intake system. Another poster here has also recently shared that he was using a cheap amazon phone USB charger plugged into his Mustang that was causing the issue as well so check for any accessories that you have plugged in.
  13. P061A & P0300 after track day

    Went to my first track day and had a blast - it was the perfect opportunity to begin to find the limits of the s550 platform. The car performed admirably! The first thing I ran into was a flickering CEL after a very hard braking zone - it didn't recur in that session but became a solid CEL in...
  14. Parting Ways with the s550.

    Good luck w/ the S650!





Top