Recent content by krishelnino

How much does Wengerd charge for a tune? Do they offer Flex fuel tunes ?

you're running your street setup on the Dorman studs without any spacer ?

Thanks, I never really paid attention to coolant level much as long as there was visible coolant in the expansion tank. I'll keep an eye out to check when engine is fully warmed up. Can i get away with adding distilled water to top up ?

so based on the suggestion on this forum from someone, I bought one Dorman 610-530 to experiment on my old hub and check to see if it would work. I was surprised I didn't have to clip the head contrary to what people mentioned about head needing to be clipped. The thick shoulder means these...

I noticed that my coolant has been below the min line when cold. Should I add the 50/50 prediluted mix or distilled water? I read somwhere that Ford made a change from orange to yellow for the coolant in recent years so not sure if I have to drain and refill or topping off would be fine ? car is...

thanks, the hole is fine probably the angle of picture makes it look that way. My concern is regarding the hub surface , it is scoured a little bit (probably indentations from washers when they tried to install new studs)

I was changing the front studs on my car today and noticed this on one of the hubs. It looks like the shop that installed my extended studs many years overtightened when installing new studs ? I also noticed a small chip on the speed sensor ring. Should I replace the hub with a new one ? Sorry...

the FP one won't

Unless I'm mistaken, if you have the lower K brace you should already have the PP1/2 lower belly pan. If I remember correctly, when I wanted to install the PP2 lip, I had to install lower PP belly ban, K brace with insulator and PP1 splitter first

I have a window mount if you're interested

What spacers do you have ?

I'd also suggest to run a 19x10 square setup with 285/35 if you want the extra sidewall. The lighter SVE wheels also made a difference compared to OEM

will the 28mm spacers work with a ARP 100-7733 stud [1' over stock] and 19x11 SVE wheel with 50mm offset and 305/30 tire? just want to ensure there is enough thread on the studs with the thicker spacer

@deng @dengstrom5 have you installed these and are they still working fine ? I just got a wheel set off Fb marketplace and the guy said those sensors are from Tirerack. I'm wondering if I should get new ones or trust the ones that are already on there

I'm looking for a set of black 25mm spacers. They show as Sold out on your website, any idea when they'll be back in stock again ?