Recent content by GTPaT

I've been using butyl glue for all the headlight retrofits I've done. https://www.theretrofitsource.com/accessories/build-materials/morimoto-retrorubber-butyl-glue.html

Yes. One is for the 4 in screen and 8 in screen Metra 99-5838CH 4in Metra 99-5840CH 8in

1. Yes, Demon eyes are LEDs on a bracket that goes between the reflector bowl and lens housing of the projector. Yes the mustang have HID projectors. 2. In the US it uses the D3S. I'm pretty sure its the same. Don't need to open the headlight to change the bulb. You can access the bulb from the...

I just installed the metra kit with a Pioneer avh-4100nex on fourth of july. Didn't get to take any pics of the install though.

Yes only the front. The rear sway bars already have them built in.

Here you go. http://www.aftermarketsuspensionparts.com/dll138

I was having the front sway bar issue. Mine shifted to the driver side a month after I installed the FRPP kit. And would bang on the frame every time you go over a bump. I probably re-adjusted it 3 times in the 8 months I've had it. I since installed lateral locks and its holding fine.

Just got mine under 3 months. Got my notice last Friday

Mine just started acting up today. But it works if the trunk is fully open. As soon I as a start to close it, goes blank about the halfway mark. Off to the dealer.

Price on FS01 19x9.5 & 19x10.5 in brushed translucent gold?

$40

Ordered back in October. Got it in 4 weeks. Sequential plates.

Mine are Red. Wait time was about 4 weeks.

Just got my revised version installed. And it's working perfectly fine now. Was able to lock my car almost a block away. Thanks diode dynamics!

This is what I have. From Amazon. $29 for a pair. [/URL][/IMG]