Yes that sounds like a good idea. Good luck! make sure whoever does the job use Dynamat top and bottom of the rear parcel tray and tighten those nuts and bolts on the subs with washers so that you dont have any vibrations. I also used some foam between the carpet and parcel shelf
Yes the Pioneers are coaxial speakers so they are a full range and do not require crossovers. If you track back a few posts i have specified the make model and pictures of the Subs. (CompC) I also installed a JLfix82 DSP with a pioneers classd 4 channel amplifier. If I was redoing the setup I...
Very nice speakers. The 6.5inch will fit. I used the Hertz 2 Way (orignally, before I moved to coaxials) and I think the woofers are the same size. I also used the factory spacers where the original speakers were install into, actually the speakers were moulded together with the spacers.
This...
Well done!! I started to read the thread and just went "all to hard" any chance you can write up a point by point summary of what to do? Just for the EQ off bit?
The OBD connection, forscan download and install etc is all well documented but where do you go to find the code and what digit do...
Exhaust is becoming like wheels too many choices. Here is another shot of the car with wheels.
Velgen classic 5 -255/35/20 on 9inch and 305/30/20 on 10.5inch.
I believe through the android settings there is a reset function. I also I think I read it on the faq phoenix site I believe that there is a pinhole somewhere that one can push in for a few seconds and it resets.
I also watched a you tube where the person reset the system.
Thats a good idea, thanks for the links. I have read up a little about it, but it confused me. If you can turn Eq off it will be very good for your setup. I really need to try this
Sounds great..If you tap off the rears just be aware that I believe they don't have a full signal and the bass frequencies are cut as well (this is what I have read) so equalising the signals could potentially be a problem as well. If you are reprogramming the ACM then you will be ok. I wish...
You have options.premium system
1. No DSP take the line out (front) direct to amp it will work but the signal isn't flat so it has some processing in it. I used a JLfix82 easy to install but still and added cost. It did however make a good amount of difference.
2. Reprogram the ACM... I did...