What approximate sizes will be needed, I'll be adding a gm/delco sensor so I'd presume 3/8 quick connect to 5/16th barbed and a length of 5/16 with either pex clamps are screw dow injection clamps line from what I'm reading?
New in box boundary OPG TSS crank gear ARP bolt MMR install bolt Boss 302 primary cam chain tensioners .All items new in box never installed. $450 shipped you pay fees
The location I'm refering was off of gilbert... to be fair it was April of 2015 and the cars were fairly new..the two techs and the manager had no clue how to align the car and insisted there was no adjustment for the rear even after I showed them where and how...they argued and gave me a hard...
Cash and check only..at Gar
All these places are closed on the weekend, and Gary's has pretty challenging hours for me to attempt to get there as I'm clear on the other side of the planet...I'll keep looking..thanks for the suggestion.
As the title states looking to get feedback on who you folks have used. Ill be needing to get some exact specs set it for an alignment...had bad luck with network alignment on my 15...open to any other suggestions..car is on bmr sp080..not too low..
Thank you again for the reply. So if I have them mirror Kelly's config I should have fairly moderate performance and no adverse tire wear? Just looking for a decent compromise between performance without skinning tires in a matter of months..what would you suggest if you don't mind me asking?
Excuse my stupidity, but I just recently got around to intalling my cb005 kit (revision 3) I believe. Does this omit the lower front bushing washer? I thought I was missing them in comparison to the photos in the instructions. I have the 4 black aluminum spacers and the 2 bracket/arms. Is this...