Recent content by Blufc3s

Thanks. What did you find to fix your issue? when I looked that sensor up on Rock Auto they list it as a “ heater core temperature sensor”. There is also a “ Cabin heat temperature sensor” listed in Rock Auto for my car that I can’t locate. I don’t want to just start throwing parts at it, but...

Never mind, I didn’t need to take the lower panel off.

2015 Mustang GT PP1, my dual zone heater is blowing cold on both sides. The air distribution works ok and the AC blows cold. i need to know how to remove the plastic panel below the steering wheel column. I can’t see any screws holding it on but i am reluctant to pull on it too hard in case...

2015 GT PP1 80,200 KMS, APPROXIMATELY 48,000 miles

Installed MBRP Catback system today

Here the system is on the garage floor. I can’t see any reason it wont fit

Interesting., makes me feel better. I will lay the system out on the garage floor tomorrow before I remove the one on the car now

Thanks, i measured the mid pipes I have and they’re exactly the same🤷‍♂️. This;

Thanks for responding, I will give it a try. thanks

My car is a 2015 GT. I just received my NIB catback and in the installation instructions it says one mid pipe is longer than the other midpipe and to put the longer one on the drivers side. The midpipes I have are exactly the same length and I can’t see any reason why they should be different...

First time out in 2026, hopefully winter is over!

What’s your mileage?

This is what’s included in my 15 GT PP1, no mention of a different clutch

I’ve had my Redlines for 2-3 years, still ok. I lay my car up in the winter and I wonder if it would be easier on the strut with the hood up as the gas isn't compressed as much. thoughts?

Did this a few years ago to my 15, still good.