Did the problem go away because mine just broke. And no one said try super glue. So when the next one breaks, which it will, the next person will have the answer. This is a common problem.
This is a common problem with broken caps. The easiest way I found to remove the broken half is to superglue (yes superglue) the top of the cap to the broken bottom half. Just be careful you don't super glue it to the reservoir. With superglue you'll be able to pull it right out, without risking...
The easiest way I found to remove the broken half was to superglue (yes superglue) the top of the cap to the broken bottom half. Just be careful you don't super glue it to the reservoir. With superglue you'll be able to pull it right out, without risking broken plastic in the antifreeze.
Ya, for some reason turning off traction control didn't work for me. My traction control was "off", with the message on the dash saying traction control off. It is possible that holding it down for 5 seconds to turn off "AdvanceTrac" may fix the power loss and power cutting out. Holding it for 5...
Yes, though one concern with this is that magnets, especially strong magnets, can interfere with electrical signals. While most cars have magnets in different locations such as a solenoid, placing a strong magnet near unshielded electrical wires may not have a positive or good effect. A simple...
I tried this but it didn't work for me. I turned my traction control off (and on) several times but it still cut power between 40-50MPH. On my car traction control is just a tap to turn off. Do you mean stability control? Its possible that might work.
As someone else mentioned, I think the...
This worked great once I realized the trick to install this part from Advanced Auto Parts. I ordered it this morning from AA and it arrived SAME DAY :). There is very little room to work near the brake pedal so it can be tricky to install. I struggled to install the brake pad stop for about an...
Same failure just happened to my 2015 Mustang. Brake pedal stop pad broke causing loss of engine power and brake lights to stay on. My vehicle wouldn't go above ~50MPH and kept ignoring gas pedal. Thanks everyone for info!!!
Might have to slightly adjust the rubber stoppers for the hood. And I do mean slightly. I would try that before bringing it to a dealership. Based on all the posts about misalignment, I can't say it surprises me.
Best of luck with your case!
If you go to mediation, they might just say it's within tolerance? I am not sure how this works. Thanks for update, I am still trying to get mine fixed.
Thanks for your advice, I appreciate your help with this! I have had two independent repair shops verify a problem related to the transmission. I'll be in contact.
Thanks Jeff! :) I could always use more assistance, I still need to get my Mustang transmission fixed and resolved. Two independent repair shops have confirmed a problem with my transmission now.