BrandonB
Tinted Window Licker
- Joined
- Jan 28, 2017
- Threads
- 3
- Messages
- 51
- Reaction score
- 53
- Location
- Central VA
- Vehicle(s)
- '18 GT Oxford 301A
- Vehicle Showcase
- 1
- Thread starter
- #1
A couple months ago [MENTION=27078]Paul@PKAUTODESIGN[/MENTION] spent a whole day educating me through PM's about wheel and tire fitment for the S550's (which I believe was a Sunday too). After the two weeks following, I could NOT figure out which direction I wanted to go. So.. I chose to pick up a cheap, middle of the road diameter/width set just to get on the car until I got my suspension setup squared away and could figure out a nicer set from there. I cannot speak highly enough of Paul, awesome dude, extremely helpful.
For $1200 and some change to my door I got wheels, tires and TPMS mounted and balanced from LMR. Threw them in the garage, until last night. My car is to be delivered this week so I decided to pull them out and ceramic coat them due to the snow and salt us East Coasters are dealing with.
AFTER completely ceramic coating everything, I noticed this.
Hint -- See the lip at the very top??
WHAT IS THAT!!! :doh:
The rest of the wheels aren't like that. Almost looks like it was taken off the CNC too early. I realize it is not LMR's fault. I realize that I have probably ruined my chances of a correction or replacement by ceramic coating it. I guess I'll still give them a call though. But DANG!..
I was hoping someone else would get a kick out of it, definitely check your SVE wheels if you've ordered any recently though.
For $1200 and some change to my door I got wheels, tires and TPMS mounted and balanced from LMR. Threw them in the garage, until last night. My car is to be delivered this week so I decided to pull them out and ceramic coat them due to the snow and salt us East Coasters are dealing with.
AFTER completely ceramic coating everything, I noticed this.
Hint -- See the lip at the very top??
WHAT IS THAT!!! :doh:
The rest of the wheels aren't like that. Almost looks like it was taken off the CNC too early. I realize it is not LMR's fault. I realize that I have probably ruined my chances of a correction or replacement by ceramic coating it. I guess I'll still give them a call though. But DANG!..
I was hoping someone else would get a kick out of it, definitely check your SVE wheels if you've ordered any recently though.
Sponsored