sigintel
Well-Known Member
- Joined
- Nov 24, 2015
- Threads
- 59
- Messages
- 2,039
- Reaction score
- 1,068
- Location
- Republic of Texas, God's Country
- First Name
- Ray
- Vehicle(s)
- 2018 GT
Put the other nuts on and torque to release some of the clamp load off the last stud. When you are pulling wheels (or a geto spacer), crack each nut like 1/8 turn reverse star pattern before completely backing any one nut off.
After you get spacer off, Use a piece of soft wood or wood with notch with adapter/spacer in vice to push all those junk studs out of that spacer. Drill all the spacer holes out 5/8” deming bit in your hand drill or drill press. Now you have a thru hole spacer. Then swap your wheel studs for longer studs since you need to change the studs anyway.
After you get spacer off, Use a piece of soft wood or wood with notch with adapter/spacer in vice to push all those junk studs out of that spacer. Drill all the spacer holes out 5/8” deming bit in your hand drill or drill press. Now you have a thru hole spacer. Then swap your wheel studs for longer studs since you need to change the studs anyway.
Sponsored