The motor has to be running and operating at normal engine temperature to do the crank relearn.Got the whipple all installed and trying to do the crank relearn and am having some issues. It’s throwing codes P0390 P0394 P0315 P0345 P0349. It stars but runs like shit any ideas??
I did do the OPG and I’m thinking the timing is off. A friend is bringing over ford PID? to verify it is the timing before we pull it apart.Did you do an oil pump gear install at the same time? If so, it sounds like the timing isn't right or there's a wire harness problem with the camshaft position sensors.
Mine run fine, but the check engine light was on.I had to do a crank relearn to turn check engine off.I want to know how the car is supposed to run after you install a whipple and tune ?? Like should it start and run just fine or does it run like shit before you do a crank relearn???
Sure was, got it all fixed and now is running like a champ!Your timing is off. Even if crank relearn is needed, it runs fine. The codes you have are accurate.
Great news Tyler!Sure was, got it all fixed and now is running like a champ!
[MENTION=13288]Whipple SC[/MENTION] quick question is a pulley from a 2.9 crusher the same as a pulley for the reg 2.9?