Dallas, TX - PPF installer?

Anyone recommend a top notch installer of Suntek in Dallas?
I put this in the regional section but didn't get but one reply.
Thanks!

Dont know about Suntek, but best xpel installer is Houston Orona 214-354-3327. He's on the west side of Addison airport. Probably worth your time to go by and check out their shop (Porsches, Ferraris, Mclarens, and a couple of GT350s when I first went by there about doing my R).

I don't know if they do Suntek, but Speed Shield in Addison does fantastic work. My friend took his 2006 Ford GT for paint correction and ceramic coating and it looks better than new, by far. 469-522-7777. I've not used them myself yet, but I plan to in the future on my GT350.

I responded over there. I am in Dallas and DFW Clearbra did my 350R - full PPF. Talk to Chris at 469.682.3497. Tell him Tony with the Black R recommended him. It was Suntek.

tlisotta said:

I responded over there. I am in Dallas and DFW Clearbra did my 350R - full PPF. Talk to Chris at 469.682.3497. Tell him Tony with the Black R recommended him. It was Suntek.

Click to expand...

Tony, so DFW Clearbra does sell Suntek? I saw Xpel but wasn’t sure if they sold anything else. I got a quote from Speed Shield and they do great work but it was very high.

Sammyd said:

Tony, so DFW Clearbra does sell Suntek? I saw Xpel but wasn’t sure if they sold anything else. I got a quote from Speed Shield and they do great work but it was very high.

Click to expand...

Yep. They did mine in SunTek for sure.

tlisotta said:

Yep. They did mine in SunTek for sure.

Click to expand...

Laser cut or hand cut on your R?

tlisotta said:

I responded over there. I am in Dallas and DFW Clearbra did my 350R - full PPF. Talk to Chris at 469.682.3497. Tell him Tony with the Black R recommended him. It was Suntek.

Click to expand...

Chris did my GT 350 2 years ago. great job

Sammyd said:

Laser cut or hand cut on your R?

Click to expand...

It was Laser. Hand cut would have been a lot more $. It looks really good and mine is 100% track car so I am not too concerned about absolute perfection.

tlisotta said:

It was Laser. Hand cut would have been a lot more $. It looks really good and mine is 100% track car so I am not too concerned about absolute perfection.

Click to expand...

I priced some hand cut ppf in Addison, and it was an additional $1600 over Chris, way too much.