Sponsored

I'm about to enhance my MT82, any concerns?

347CobraII

Well-Known Member
Joined
Jul 16, 2015
Threads
5
Messages
803
Reaction score
103
Location
iowa
Vehicle(s)
2015 GT
NO oil, clutch line, helper spring, shifter going to fix it just band-aid. Not everyone having the problem either but some have. Most part its clutch not releasing fully especially at high RPM and then it gets worst overtime in tell trans is hurt. Hint why Ford using dual disc in GT350 and 2018 mustang.
There is big difference driving car with dual disc clutch
Sponsored

 

georgiarocker

Active Member
Joined
Mar 25, 2016
Threads
4
Messages
30
Reaction score
4
Location
Georgia via Germany
Vehicle(s)
2016 Roush Warrior S/C
I replaced my slave cylinder assembly with the mcleod recently. It's (supposed) to be a direct replacement for the stock one (with a beefier spring). It's not necessarily. Lesson learned... the input tube connector did not extend out the hole in the transmission as far as the stock one. Make sure you replace the plastic insert into the tranny and install the plastic elbow connector BEFORE reinstalling the transmission. If the elbow connector doesn't snap onto the feeder tube properly, you may have to bend the tube slightly. I made the mistake of reinstalling the transmission before checking for proper fitment. Big mistake.
 
 




Top