galaxy
Well-Known Member
- Thread starter
- #1
So I discovered this today while checking tire pressures. I’m sure like most, I have my favorite gauge display on the center screen where I always operate. I keep mine just below the air/fuel ratio so I can see all the pertinent numbers. Every time I shut down, the screen always reverts back to the parent screen; it never stays put, but it does go directly back to the previous setting as soon as I select the gauge submenu.
Well today, I left the tire pressures up on the screen to serve as a reminder on the next start to check cold pressures as I knew it would go to this screen. Lo and behold, as soon as I started the car, it was already on the tire pressure screen. It did not default back to the parent screen like it normally does. Is this a preprogrammed/locked screen or something based on some heirarchy?
Well today, I left the tire pressures up on the screen to serve as a reminder on the next start to check cold pressures as I knew it would go to this screen. Lo and behold, as soon as I started the car, it was already on the tire pressure screen. It did not default back to the parent screen like it normally does. Is this a preprogrammed/locked screen or something based on some heirarchy?
Sponsored