Fit to be tied with backspacing.

[Old5.Oguy]

That pattern is for Nissan.

Have them recut the rears for at least 35mm.

Can you make those work? Yeah but you'll need to camber the snot out of them.

Fingers crossed. Fronts won’t be the issue but the rears I’ll find out tmrw.

Sponsored

 

[mavisky]

30 is a bit aggressive, but should be fine with the 285's. Per the calculator on Fitment Industries, your setup will be about 7mm further outside the fenders than my "street" setup per side.

Or about 9mm further out than my competition setup.

 

[Old5.Oguy]

Thanks for the Info. Fingers crossed. I’m guessing you have zero issues with the tires rubbing or when you hit any bumps? It’s not my daily and sits in the garage most of the time but I’d rather not cause any damage if I hit a decent bump. Thanks again

 

[Old5.Oguy]

Went to the wheel place today, wound up with the rear offset at 37 and the fronts at 32. The fronts are tucked in just past the fender with plenty of room. Rears are about 1/8 of an inch past the fender and looks great. Plenty of room between the fenders and tires. Thanks everyone for your input.

 

[TonyNJ]

Went to the wheel place today, wound up with the rear offset at 37 and the fronts at 32. The fronts are tucked in just past the fender with plenty of room. Rears are about 1/8 of an inch past the fender and looks great. Plenty of room between the fenders and tires. Thanks everyone for your input.

So it was the suspension hanging after all.

 

[Old5.Oguy]

So it was the suspension hanging after all.

Yes Sir. For the second time in my life things went my way, lol. Thanks again.

 

[MD18EcoStang]

Wow, that was a lot of worrying for nothing! Glad it worked out!

PS - Nice looking wheels too!

 

[Old5.Oguy]

Wow, that was a lot of worrying for nothing! Glad it worked out!

PS - Nice looking wheels too!

Yeah luckily the guy added to the offset and it fit perfectly. Slightly aggressive looking but not obnoxious. Thanks for all the advice.

Sponsored