tamadrummer1120
Well-Known Member
- Thread starter
- #1
As you can see by my signature, MT82 car, just wrapped up a VMP install with a 79mm pulley. Have all of the BMR suspension goodies with MGW shifter.
Everything drivetrain wise is stock. My current plans are listed as follows then I can head to the track (MIR) and not break everything.
McLeod MST Clutch (MXT is the on to avoid right?)
One piece driveshaft-considering driveshaft shop (aluminum or carbon fiber really matter THAT much for my power level and goals of maybe 10's?
Axles-DSS as well unless there is an issue there
And then the great debate over finding some sort of sticky tire I can use on my current wheels which are probably too heavy, or get some welds or some other drag racing wheel for the rear and one of the 4,000 suggestions for tires.
Anyone think of anything else?
Everything drivetrain wise is stock. My current plans are listed as follows then I can head to the track (MIR) and not break everything.
McLeod MST Clutch (MXT is the on to avoid right?)
One piece driveshaft-considering driveshaft shop (aluminum or carbon fiber really matter THAT much for my power level and goals of maybe 10's?
Axles-DSS as well unless there is an issue there
And then the great debate over finding some sort of sticky tire I can use on my current wheels which are probably too heavy, or get some welds or some other drag racing wheel for the rear and one of the 4,000 suggestions for tires.
Anyone think of anything else?
Sponsored