SK GT
Well-Known Member
- Thread starter
- #1
I finally got around to installing this today. I have a non PP car so wanted something a little more aggressive but not over the top. I was going to originally do a PP splitter but that also requires a PP Bellypan.
The CS splitter is a little bigger than the PP one and works with the non PP bellypan so it was a win win for me.
Install wasn't too bad. The bellypan does have to come down to install it as there are push pins that hold the splitter to the bumper on the sides that go in from the top. You may could get to them if you remove the wheel liner or just pull it way back but I found removing the bellypan easier.
Onto the pics. Sorry they are crappy and the car is really dirty. If you have any questions please ask.
-SK
The CS splitter is a little bigger than the PP one and works with the non PP bellypan so it was a win win for me.
Install wasn't too bad. The bellypan does have to come down to install it as there are push pins that hold the splitter to the bumper on the sides that go in from the top. You may could get to them if you remove the wheel liner or just pull it way back but I found removing the bellypan easier.
Onto the pics. Sorry they are crappy and the car is really dirty. If you have any questions please ask.
-SK
Sponsored