Steeda Clutch Spring Issues

Has anyone installed the Steeda Clutch Assist Spring and had any issues down the road? I have heard of some people removing the stock spring and eventually having issues withe the slave cylinder and other clutch parts.

that typically happens when you run without the assist spring. i havent had any issues but have only had it for about 8k miles. i havent heard of anyone else with issues yet tho

That's good to hear. I'd hate to throw it on there and get a couple thousand miles down the road and have some issue and then the service folks at Ford tell me that warranty won't cover the repairs due to a $15 spring.

could always put it back on assuming you dont break it like a lot of people taking it off. theres no way i can imagine they could tell if it was taken off and put back on unless it was broken

Not a single issue. Ran without the spring for over 20k miles and then had the Steeda spring on for about 22k miles so far.

BmacIL said:

Not a single issue. Ran without the spring for over 20k miles and then had the Steeda spring on for about 22k miles so far.

Click to expand...

No spring in mine for 6 years and well over 50k miles. No issues.

Have the lighter steeda spring in mine for 20k miles or so, no problems at all

No problems here either, though it's only been on for 1000 miles so far on the car. I did break a tiny part of the perch removing it but it wasn't bad enough to not be usable again.