assclown
Warchief
- Joined
- Apr 2, 2015
- Threads
- 18
- Messages
- 285
- Reaction score
- 53
- Location
- GTA - Canada
- First Name
- Dee
- Vehicle(s)
- 2015 GT Vert
- Thread starter
- #1
Guys, looking for some advice on two issues with my headers install and how to resolve them?? :cheers: [MENTION=10926]beefcake[/MENTION] cough cough
Installed the pypes headers with the following issues:
1) Steering shaft is rubbing against one of the header pipes. I did not try going in the car and turning the wheel, however a business card cannot even be slid between the pipe and the shaft.
2) the passenger side O2 sensor without any fouler or adapter is resting on the transmission mount nut, which will break off right away if I mount it up it. The 90 degree elbow adapters I have can't be installed as when they turn hit the mid-pipe :headbonk:
Pictures below
O2 Sensor / Transmission Mount bolt
Steering Shaft :(
Cheers
Installed the pypes headers with the following issues:
1) Steering shaft is rubbing against one of the header pipes. I did not try going in the car and turning the wheel, however a business card cannot even be slid between the pipe and the shaft.
2) the passenger side O2 sensor without any fouler or adapter is resting on the transmission mount nut, which will break off right away if I mount it up it. The 90 degree elbow adapters I have can't be installed as when they turn hit the mid-pipe :headbonk:
Pictures below
O2 Sensor / Transmission Mount bolt
Steering Shaft :(
Cheers
Sponsored