FATHERFORD
Well-Known Member
- Thread starter
- #1
EDIT: HPP Racing kit is off the car, and went with the Boost Works kit, check later in the thread!
There is another manufacture making a twin turbo kit for the 15's. They are using my car of R&D.
We started on it before hellion put theirs out, so NO we are not copying Hellions ghetto setup(if you saw it at sema you would know what I mean). Which I'm sure is not there final kit, they just wanted to be the first to say "we are first twin tubo".
The system will be 100% American made out of high quality stainless steel. Not that cheap stainless hellion makes their kits out of(you can stick a magnet to their "stainless")
My car is a Premium GT with an auto and 3.15 gears.
Picked the car up at the dealership with 8.5 miles on it.
Then promptly put a mile on it in the parking lot...
[ame]
I then drove it over to Northstar Dragway to drop it off with the builder and see if they would let us take a pass down the track, but it was a big 275x race so the track didn't want street tires messing up the starting line.
We put it on the dyno to make a baseline run where it put down 389rwhp.
Then there was a lot of planning, but it is finally coming together. I'm not going to post a lot of pictures yet, as he does plan on selling this. After it's all said and done I will be posting lots of pictures.
There is another manufacture making a twin turbo kit for the 15's. They are using my car of R&D.
We started on it before hellion put theirs out, so NO we are not copying Hellions ghetto setup(if you saw it at sema you would know what I mean). Which I'm sure is not there final kit, they just wanted to be the first to say "we are first twin tubo".
The system will be 100% American made out of high quality stainless steel. Not that cheap stainless hellion makes their kits out of(you can stick a magnet to their "stainless")
My car is a Premium GT with an auto and 3.15 gears.
Picked the car up at the dealership with 8.5 miles on it.
Then promptly put a mile on it in the parking lot...
[ame]
I then drove it over to Northstar Dragway to drop it off with the builder and see if they would let us take a pass down the track, but it was a big 275x race so the track didn't want street tires messing up the starting line.
We put it on the dyno to make a baseline run where it put down 389rwhp.
Then there was a lot of planning, but it is finally coming together. I'm not going to post a lot of pictures yet, as he does plan on selling this. After it's all said and done I will be posting lots of pictures.
Sponsored
Last edited: