Boston23
Well-Known Member
- Joined
- Jun 16, 2015
- Threads
- 13
- Messages
- 564
- Reaction score
- 605
- Location
- South Carolina
- First Name
- Bruce
- Vehicle(s)
- 2017 GT PPP Ingot Silver
- Thread starter
- #1
I’ve been looking at these for a while. The local dealership where I get service also has a Roush division. There were a couple of used Roush’s where the corner of the extractor was lifting which is something that bothered me. I finally ordered a set and found the two halves are held together with 6 screws and double sided tape on the exterior touch points. I removed the screws and gently pulled the two halves apart. I now understand why the front corner lifts as the double sided tape releases over time. I stripped the double sided tape off and cleaned them up with alcohol. I’ll put them back together with amazing auto goop and clamp them and then prep them for paint.
Sponsored