New Best with Kenne Bell 3.2

Got my car down for the second time with the new Kenne Bell setup. Air was decent and track was hooking. Best run of the night was a [email protected]

I'm pretty happy with that time although I know it has some more in it with a better launch. I slipped the clutch at 4,500 thinking the tires wouldnt hold but they did. Should have launched harder oh well. This was on 295 Mickey Thompson drag radials

Here is the video of the pass although its not the best quality. Turn up your speakers!

[ame="[MEDIA=youtube]fPDgQ8R8fKA[/MEDIA]"]

Nice. You need to run it with some slicks

armykyle1 said:

Nice. You need to run it with some slicks

Click to expand...

Definitely need some slicks so I can launch harder.

Nice pass.
Can you post your slips?

what pulley?
8 or 6 rib?
stock or 20 % OD if 8 rib?
E85?
I have an 8 rib/20 OD /3.2KB set up and ran almost the exact same time with the MT85/3.31 last year and again this year with the Tremec/3.31 this year(increased engine displacement by 0.20). Same 29 inch tall 305/45 18 ET R's.
4 inch pulley/13-14 psi boost.

Picked up 10-14 mph going to the 3.5 pulley although car is also a bit lighter with rear seat delete/17 inch drag wheel set up/18 inch Hoosier slicks and skinnies.

60 ft did not get better and car is still a dog to the 1/8 mile but is making steam after.

Did you ever swap your 3.73;s for 3.31 Rear end gear ?

The 3.31/28 inch tire combo works well with MT82 but is too tall for the 2.66 first gear treemc

Going to try a 26 inch tire which will change gearing to 3.55(with 18 inch tires) but will eventually swap in the 4.11's.

Here is the slip from the best run. I have a few others around 11.0 at the same mph as I tried to figure out the launch.

Here is the total Mod list:
3.2 KB
3.75 pulley (6 rib)
Stock crank pulley (no OD)
93 Octane, Lund Tune
Longtubes
MT82 with McLeod RST
CF Drive shaft
DSS800 Axles
Rear gears swapped to 3.31
27" MT ET Street SS Drag Radials, Full size 20" front wheels

How much boost?

KYLExKILLJOY said:

How much boost?

Click to expand...

Don't know exactly since the Ecoboost gauge isn't accurate and I don't have a real gauge for it. Based on the pulley and what KB is telling me it should be around 12psi with the long tubes.