Sponsored

Finally here!!

CooterK

Well-Known Member
Joined
Dec 14, 2014
Threads
7
Messages
279
Reaction score
68
Location
Bay Area, CA
Vehicle(s)
2015 Ingot GT PP
That splitter is beautiful. Judging by how my stock plastic one looks right now if I had a carbon one it would be in cracked all over by now.
Sponsored

 

gundam83

Well-Known Member
Joined
Oct 30, 2014
Threads
35
Messages
274
Reaction score
37
Location
Sacramento, CA
Vehicle(s)
2015 Mustang GT Oxford White
I noticed you did not use the support rods with the Apr splitter. I thought it was highly recommended. Is it okay to run it without? Also how difficult is the install? Can it be done without taking the bumper off?
 
OP
OP
jayman33

jayman33

Well-Known Member
Diamond Sponsor
Joined
Aug 9, 2014
Threads
197
Messages
2,619
Reaction score
1,071
Location
Fort Bragg, NC
First Name
Jason
Vehicle(s)
15 PP
I noticed you did not use the support rods with the Apr splitter. I thought it was highly recommended. Is it okay to run it without? Also how difficult is the install? Can it be done without taking the bumper off?

You will need to take the bumper off, install isn't cut and paste unfortunately. We're going to use the support rods but we need to fab up some pieces.
 

SIMS1724

Well-Known Member
Joined
Sep 11, 2016
Threads
10
Messages
75
Reaction score
16
Location
ST. LOUIS
First Name
Jake
Vehicle(s)
2017 Mustang GT/CS Ingot Silver
Looks Good!
 

Sponsored

OP
OP
jayman33

jayman33

Well-Known Member
Diamond Sponsor
Joined
Aug 9, 2014
Threads
197
Messages
2,619
Reaction score
1,071
Location
Fort Bragg, NC
First Name
Jason
Vehicle(s)
15 PP
HRE FF15 in fog installed, Thanks to Diode Dynamics, was able to put their whole selection on the GB. AP Racing Radi Cal from Stillen brakes.

I left the numbers at the shop with the weight we saved going from PP wheels and PP brembos to the AP Racing and HRE's. Good savings though. Now just working camber out.
LR 1.jpg
LR 2.jpg
LR 3.jpg
LR 4.jpg
LR 5.jpg
LR 6.jpg
 

A.Mustang

Well-Known Member
Joined
Jul 11, 2016
Threads
9
Messages
85
Reaction score
6
Location
Swedesboro, NJ
Vehicle(s)
Mustang 5.0
i know this is an odd question, but where is your lift placed at on the underside of the car? is it on the pinch welds or what spot are you using?
 
OP
OP
jayman33

jayman33

Well-Known Member
Diamond Sponsor
Joined
Aug 9, 2014
Threads
197
Messages
2,619
Reaction score
1,071
Location
Fort Bragg, NC
First Name
Jason
Vehicle(s)
15 PP
On the pinch welds but we use braces
Sponsored

 
 




Top