Two 19x11 Square Setup Installs

Any moderator know why [MENTION=14107]tyshenry[/MENTION] got banned from this forum?

Update: Tyson was accidentally banned but he's back now.

Welcome back, [MENTION=14107]tyshenry[/MENTION]

Competition Orange said:

Thanks for contributing this information to the thread.

Have you been able to measure the difference in thickness between stock and afe struts up front?

Click to expand...

Not yet. I was at Road Atlanta last weekend and am on my way to pick up the car and trailer at RA now after a little family vacation. Then VIR this weekend. I can probably measure next week.

Brent Dalton said:

Not yet. I was at Road Atlanta last weekend and am on my way to pick up the car and trailer at RA now after a little family vacation. Then VIR this weekend. I can probably measure next week.

Click to expand...

Jealous!

Thanks.

Updated first post with some pics/clearances.

Killspray said:

Front Spacer: 20mm
Camber: -2.8°
Clearance to Strut: 4.5mm
Camber Bolts: No

Click to expand...

This looks just right. I think I'm going to go this route with the SVEs in 19x11.

Thanks for doing this research, very very helpful!

I agree, if I could do it again, I'd go 20mm

Killspray said:

I agree, if I could do it again, I'd go 20mm

Click to expand...

Why can't you?

EDIT: Sorry, just saw your most recent post. That looks like a nightmare.

Swedish_Fries said:

Why can't you?

EDIT: Sorry, just saw your most recent post. That looks like a nightmare.

Click to expand...

Well he can. And what do you mean that looks like a nightmare?

Swedish_Fries said:

Why can't you?

EDIT: Sorry, just saw your most recent post. That looks like a nightmare.

Click to expand...

Ah, I didn't specify. The 25mm spacers are mine. The 20mm spacers are [MENTION=14107]tyshenry[/MENTION]'s. I'd have to buy new spacers... unless Tyson wants to hook a brotha up ;-)

what brand spacers are the 20mm?

I am wanting to do 19x11 SVE gt350 with a 305_35_19 MPSS. Do you think that would fit with the 20 mm spacer and say -2.0 degrees front camber?

rcb020 said:

I am wanting to do 19x11 SVE gt350 with a 305_35_19 MPSS. Do you think that would fit with the 20 mm spacer and say -2.0 degrees front camber?

Click to expand...

All the specs are in the first post, and even right above your post...

You'll need extended studs and open lugs.

Competition Orange said:

All the specs are in the first post, and even right above your post...

You'll need extended studs and open lugs.

Click to expand...

Just trying to confirm because the tire sidewall will be different than what was tested, and I think MPSS run a little wide so I was thinking 25 mm might be safer bet.

rcb020 said:

Just trying to confirm because the tire sidewall will be different than what was tested, and I think MPSS run a little wide so I was thinking 25 mm might be safer bet.

Click to expand...

Yeah, if you are running camber bolts then 20mm spacer probably isn't going to work.

I'd buy both 20mm and 25mm to test both, they aren't that expensive.

I didn't notice the aspect ratio difference.

I'm not sure anyone has done your specific size yet. 25 does seem a safer bet, but then again, I believe he had almost 5mm to spare using the 20mm spacers.