CEL on after catch can installation

So I just installed a boomba catch can and now my CEL is on, any ideas?

Check all connections for a vacuum leak.

You can either go to autozone and have them read the code for you, or invest in a OBD2 scanner and read the codes. It's a useful tool to have and cheap:
https://www.walmart.com/ip/OxGord-CAN-OBD-II-Scanner-Tool-for-Check-Engine-Light-Diagnostics-Direct-Scan-and-Read-Out/150731313?wmlspartner=wlpa&selectedSellerId=693&adid=22222222227046941441&wmlspartner=wmtlabs&wl0=&wl1=g&wl2=t&wl3=146934810922&wl4=aud-261800281660la-257964074393&wl5=9004370&wl6=&wl7=&wl8=&wl9=pla&wl10=112354462&wl11=online&wl12=150731313&wl13=&veh=sem
This will tell you what the issue that is throwing the code

Thanks guys. I picked up the scanner after confirming no leaks, gave me a code of P0443 which appears to be something with the fuel Evap system. Does anyone know where the solenoid is located for the purge valve so I can begin there? I am under warranty still but am assuming I did something in the process of getting the intake manifold off to reach the crankcase breather.....

I have searched online and cannot find anything other than generic info, has anyone else ran into this?

The purge valve is located just under the engine cover, it has BOSCH written on it and has a connection that goes to the top of the throttle body. Probably you did not correctly connect the connector.

Ok I feel stupid, I just left the sensor unplugged because the connector got tucked under the wiring harness and I didn't see it. Thanks for the help guys!