15" weld bead lock drag set up with baer brake

Stangrcr67 said:

Where can you find this brake kit? I've been looking for anything on being able to run 15in rear wheels but havent found much that doesnt need more work done besides just the instal of the kit.

Click to expand...

cj pony parts, juggernaut, and Carlyle racing sells them. youll need brake hoses and to shave the head down on one bolt on each side to clear this set up. the rear wheels are 15x9.33 with a 6.5 back spacing.

I bought the baer setup and ordered the wheels. I was told i had to change the bolts. What do you mean by you had to shave the head down on one bolt?

[/QUOTE]

TT15GT said:

I bought the baer setup and ordered the wheels. I was told i had to change the bolts. What do you mean by you had to shave the head down on one bolt?

Click to expand...

ive replaced the factory front rotors with the matching baer set up also

sry to dig up an old thread. Where did you get the Welds from do you mind sharing price?

I bought them used from on3. Wheels, rear tires, and rear baer brakes $2900.

S550zimmy said:

I bought them used from on3. Wheels, rear tires, and rear baer brakes $2900.

Click to expand...

They look awesome. I have the same brakes. Looking for the Welds now.

Theres a guy in the forsale section selling a set

TT15GT said:

Theres a guy in the forsale section selling a set

Click to expand...

Could you post the link? Couldn't find it. Nevermind found it.

I used the aerospace rear drag kit. Worked good. I used sve drag wheels 15x10. But yes the wheel barrel wanted to hit the spindle on the inner wheel edge. Used a 3/8 spacer and grinded some. 1/2 inch spacer and longer studs would have fit better. Traded my car in. Brakes are just sitting in my garage now lol.

Looks expensive..........badass look.

They were and I bought them used too.

S550zimmy said:

cj pony parts, juggernaut, and Carlyle racing sells them. youll need brake hoses and to shave the head down on one bolt on each side to clear this set up. the rear wheels are 15x9.33 with a 6.5 back spacing.

Click to expand...

Are the brake lines for the rear a requirement? I haven't installed mine yet. If so what am I looking for as a replacement?

No you can use a Dorman banjo bolt part number 13912. You can get that at any parts store