zackmd1
Well-Known Member
- Thread starter
- #1
I have finally got my illuminated cup holders installed today! Mostly pic intensive thread here. I followed instructions on how to remove the center console top from CJ Pony parts shifter install video. Came out much easier then I thought without any broken clips. From there the cup holders are bolted to the top section of the console. Remove the bolts and replace the base model cup holder assembly with the new one.
I tapped into the shifter lighting circuit for my power. The OEM illuminated cup holders have 4 wires. One is of course ground but the other three are blue, green, and orange. These wires correspond to the RGB led. (Blue/Blue, Green/Green, Orange/Red) You can have almost any color that you would like by crossing different wires. I chose to cross the blue and green wires to achieve a more teal color that would closely match the OEM lighting.
Total install time was about 2 hrs. Most of the time was spent wiring/soldering.
Part Number of cupholder: FR3Z-6313562-BC
I tapped into the shifter lighting circuit for my power. The OEM illuminated cup holders have 4 wires. One is of course ground but the other three are blue, green, and orange. These wires correspond to the RGB led. (Blue/Blue, Green/Green, Orange/Red) You can have almost any color that you would like by crossing different wires. I chose to cross the blue and green wires to achieve a more teal color that would closely match the OEM lighting.
Total install time was about 2 hrs. Most of the time was spent wiring/soldering.
Part Number of cupholder: FR3Z-6313562-BC
Sponsored