Steeda's Race Car Development - Build Thread

Grintch said:

Yes, but do you have to cut a hole to let air flow escape? Not something you would want to do on a dual purpose, or just occasional track car.

Click to expand...

Yes we do have, flow vents in the rear. Amazingly its high enough,that racing in the rain we had no water intrusion.

Can you snap a picture of the exit?

Grintch said:

Can you snap a picture of the exit?

Click to expand...

Sure, will do early next week.

Steeda Pro-Action struts installed on the 20 car.

SteedaTech said:

Steeda Pro-Action struts installed on the 20 car.

Click to expand...

Off to the races this weekend at Palm Beach International Raceway!

Two SARRC Races. Plus, an hour and half endurance race.

Will keep everyone posted.

SteedaTech said:

Off to the races this weekend at Palm Beach International Raceway!

Two SARRC Races. Plus, an hour and half endurance race.

Will keep everyone posted.

Click to expand...

Qualified 1st in the SAARC sprint races. Qualified 1st and on the pole for the endurance Race.

Finished second in the first race, spun out on second lap.

Finished first in the second race.

First over all and in class in the enduro, despite losing the clutch at 3 minutes to the end.

More pictures and details next week.

SteedaTech said:

Qualified 1st in the SAARC sprint races. Qualified 1st and on the pole for the endurance Race.

Finished second in the first race, spun out on second lap.

Finished first in the second race.

First over all and in class in the enduro, despite losing the clutch at 3 minutes to the end.

More pictures and details next week.

Click to expand...

Awesome! Congratulations Team Steeda:first:

Yes!

TJ

tj@steeda said:

Yes!

TJ

Click to expand...

Another good pic

Under hood Maintance

Pic of the engine compartment

Wilwood rear brake and stop the hop photos

20 car rear suspension photos. Look at the structural integrity of the IRS brace. It just kicks butt!

SteedaTech said:

20 car rear suspension photos. Look at the structural integrity of the IRS brace. It just kicks butt!

Click to expand...

Getting ready for Homestead this month

1. New carbon fiber lightweight Hood and Deck lid.
2. New Exedy clutch
3. Higher rate rear springs
4. New Wilwood rear brake setup
5. 355 gears installed
6. New Front control arm to correct front roll center

NIIIIIICE! I want that same hood g'dammit!!

And I want that control arm.

Such a beast!

D*MN, that hood should keep the heat flowing outta there pretty nice.

WhiteyDog said:

D*MN, that hood should keep the heat flowing outta there pretty nice.

Click to expand...

Absolutely! Love your avatar!

Mike D