Search results

I hope thats the answer also, it turned out I had to replace both lines. I made the mistake of over charging the system afterwards which caused it to cycle on and off every few seconds. I bought a better gague and let some refrigerant out, workes great now. I was able to reach both lines through...

I just completed installation of the new low pressure AC hose. All went smooth, like I said before the one nut by the condenser was hard to reach. The only thing I moved was the coolant overflow container, just moved it aside. There was no refrigerant left when I removed the hose. Recharged the...

I ordered the hose $89.00 looks easy to do, the hard end to reach will be where it attaches to the compressor. I will let you know how it turns out.

Well decided to check again with a gauge and had to recharge more so a leak. Used the refrierant with dye and noticed it was leaking from the low pressure hose just before its atached to the compressor. Anyone replaced this hose and was it difficult?

I think I got lucky. Yesterday I tryed to add refrigerant with no luck, but tryed again today and to my suprise the ac cluch kicked in, cold air starting blowing. Now I will have to wait and see if there is a leak.

Where is the pressure switch located and can I access it? There is no noise from my compressor and no burning of the belt. I just checked the cluch and it rotates freely. Any ideas?

Sorry to hear that, if you could let me know what they did and was it Ford sevice or an independent shop?

My GT350R 2019 tryed the ac for the first time today only hot air. I charged it checked the compressor cluch fuse and replaced the compressor cluch relay, still no luck. Any other ideas before I take it for service and with no warrenty it could become quite costly:frown: Hey did not realize the...

I just got my 2019 GT350R, has cup 2 tires with only 1500 miles on them. I priced out ps4’s at my local DT and came in around 1800 mounted. Is the ps4 still the tire of choice for summer driving?

Hey all, maybe I am being a little OCD but after close inspection of my Oxford White I noticed the front and rear plastic bumpers are slightly off color, is this normal? Maybe a little yellowed from the sun, anyone else have the same issue?

Found out the hard way, small scratch on lip of hood :frown: Touched up with paint I had from my GT500.

Yes I am, make sense now, thought there was some thing wrong, thanks for the clarification.

I fiinally was able to wash my car, it was a balmy 40 degrees today. Noticed the front carbon fiber wheels on the inside are not finished like the rears or has heat affected the paint on the front wheels. Second noticed you cannot lift the driver side wiper without hitting the hood, is this...

Spoke to Granger yesterday and will get quote today, I will not need an inspection since my car is blue certified from the dealer I brought from.

I just bought a 2019 GT350R 9K miles never tracked. Could use some help on best low cost option for an extended warrenty.

By the way after I sold the 500 last year I ordered a 24’ gt5.0 loaded. Took 4 months to show up at the dealer and took one look and hated it. If you are traditional Mustang the 7th generation was not for me or you, another reason I went back.

Hey I remember you from the 500 forum back when we were waiting for ours to be built😊what year is your R?

Thanks for the reply, I got bored of the GT500 automatic trans, I don't race so paddle shifting never thirlled me. Have owned lots of high end sports cars all with manual, just missed having. Had a Ferrari F355 with F1 trans sold after 4 months to get a manual. Being in my mid 60's I thought...

Hey all, have owned a 16' GT350 base, 17' GT350 base both have been sold, then ordered 20' GT500 base just sold and now back to GT350R this time, wanted manual back. I have a paint question, car has clean carfax owner says never painted anything on the car but when looking under the hood at the...

That car has a lot of miles on it.