Search results

Does any one know what will need to be changed or acquired to install a 2011 gen 1 shortblock into a 16' mustang? The gen 2 adapter has coolant lines for the oil cooler gen1 does not. Can you just bolt on the gen1 adapter and not hook up the cooler? any one done this yet, any suggestions?

So I have decided to do some upgrades and ran into a new forged short block. It has Manley forged h-beam rods, Manley pistons(10.5 to 1) and arp studs everywhere, it is a 12mm head bolt engine which I also have studs for. Goal 1200-1300whp already have billet oil pump gears and crankshaft...

I was driving home from work, just got my new 555r’s on the car and decided to open it up car downshifted into second was making about 10lbs of boost tires spun just a little and then boom!!! Car stops pulling. I coast to a stop and I have no forward or reverse only grinding noise. Towed home...

Well I finally got the car to the track and made some passes. Best pass of the night was 11.0 at 135mph on 7lbs of boost with a 2.0 60ft. I could not get the car to launch without pushing through the lights on the foot brake. I was happy with the mile an hour for only 7 psi. Obviously I have a...

During my tuning sessions with Lund they said my iat temps are too high. During a 3rd gear pull from 3000-7200 with a starting temp of 94 degrees I'm seeing an increase to 140 in just that single gear pull. That was at 7-8psi, I did another pull with 10psi pull and had a similar increase but not...

I have finally got to a point that I am ready to take the car to the track. I have a few questions and looking for some recommendations before I go. I have had similar power car but all have been either manuals or race powerglide setups. This being the first real street car with an auto not sure...

Well I've made some headway and want to post some pics and info on what I've got done so far. First off while waiting for the kit I installed my BMR suspension components, DSS 1400 hp axles and 1 piece drive shaft wrapped in BMR driveshaft loop. Also installed Viking shocks and BMR...

Seen lots of not so positive results with the use of these setups. But not much recently, any recent good or bad info on these transbrakes?

Finishing twin turbo build that will be in the 800whp range, what is the best front and rear setup for 17" wheels today? I know we have had some new choices out and wanted some up to date info. Does not have to be street legal tire but would be nice if it was. What are the guys(or gals)...

So I am getting close to having my full kit here from boostworks and as I near my final install I am looking for any other recommendations to finish off my build. Here is a quick run down of current mods. -opg and crankshaft gear -boostworks twin 58bb comp turbo kit -3" bassani exhaust...