Wiring wasnt bad... just follow the diagram. Have your tuner adjust the gear ratios in your tune to match the xl and your cruise should work just fine!
Got her finished up yesterday! .. Unfortunately she is coming back out this weekend to do a little tunnel massage. I didnt realize how tight the reverse solenoid was to the tunnel. So far really impressed and love the gearing! Took out a street bike yesterday on the 4 lane in town. In...
Just got my Mag XL today! taking out the MT82 this weekend and doing the swap. Have to do it on my back in the garage... anybody that has done the swap have any pointers I appreciate it?!?
Im just saying it was still climbing and Im sure would of made more hp with more rpm... im more then happy with the power level on the 3.75 right now till i have a shortblock built. I just wanted 700+ on pump and got 740
Thank you everyone. Super happy with results. I could of chased 750 with a 8k pull. But until my built shortblock is done I’m more then happy with results. Car is a straight up blast to drive. Torque is everywhere. Love it!
Just got back from dynoing my stage 2 gen 3 kit. 2016 car. 12k miles. Longtubes with no cats. 93 octane. 3.75 pulley. Pbd tuned. Would of made a little more if I pulled to 8k but still very happy with numbers at 7500
Just got back from dyno today...finished my install last week. Stage 2 Gen 3 kit from pbd. 3.75 pulley. 93 octane. Longtubes and no cats. Could of made more if I pulled to 8k but more then happy!
I just installed my Gen 3 Stage 2 kit last week. Here are some of my thoughts..
Ive done limited driving. Just logging and a couple spirited sprints down the block. The install was long but easy. Directions were good. Everything is labeled. I was shipped some wrong hardware with my kit...
I appreciate the recommendation. I’m trying to hold off on drive shaft as I plan to ditch the mt82 myself in the near future. Send me a pm on what ya ur asking for it please. If it’s a good deal maybe I’ll buy and use then just resell when time comes. As of now I’m staying stock balancer...
Im pretty confident I can handle it all on my own.. ive done alot of pushrod foxbody stuff ect.. But the more I think about it it might be more cost effective to have someone do it. Work hasnt slowed down this winter and I can be making money on the weekends ect...
I have a ton to...