Search results

Try 281 motorsports...they are a mustang house...not sure what they would charge but they are in your area.

I have almost a complete PP suspension. Springs DAmpers sway bars front and rear I am located north of SAnta barbara in Lompoc.

Is anyone tracking the highway one closures? This might make for a small problem getting to Sand City from Cambria? http://www.dot.ca.gov/hq/roadinfo/display.php?page=sr1

what wheel specs did you use for the 295/30/19 up front? Will that configuration fit the project6gr front wheel(19x10)? I just bought 19x10" from and 11" rear, set looking for as much tire as I can comfortably fit up front.

Where did you get the tow hook?

I was hoping to use a couple of new ones also from the gt350. But ford parts department does not even have the part number or a listing for them!

Did you use the rear GT lower springs seats?.. I have my set of GT350R rear springs and upper spring seats at the house. The lower seats (called pads from Ford) that are listed as RH/LH in the levitown/fordparts systems for the GT350R are the ones for the right hand side will not work. There...

I have the full 350R set coming from Levittown...just waiting on shipping! The "X" is the models I have arriving as well.

Can you post the part numbers of the springs you chose? I have checked levittown and fordparts.com and there are multiple part numbers listed for the gt350R

Was just looking at LEVITOWN Ford site and there are 10 different part numbers for the rear springs!? And a similar number for the fronts... Where are you guys getting the numbers from? Who has bought both the gt350R front and rears and can post part numbers...

I find the handling springs are a little to stiff for rear I had to loosen rear sway and tighten front trying rein in the rear of the car. So with that I am concerned about installing a softer spring up front upsetting the balance. I figure the Ford engineers probably did a pretty good job...

I am very interested in how this comes out... Currently I am running bmr handling springs 300 front 980 rear with koni yellows all the way around And car sits a little to low in front me (jacking rails to the rescue)

Has anyone tried Motul DCTF? according the product sheet it meets the ford specification called out in the owner manual(WSS-M2C-200-D2)

How much will these raise the rear of the car?

This set looks promising... http://www.fulltiltboogieracing.com/2015_S550_Brake_parts.htm

So if this is their deal...Anyone have any info on when bilstein will have theirs available?

I ended up pulling the knuckles and taking them to a machine shop....problem solved

I used my floor jack under the rear spring perch and raised the rear suspension to the point where the car just started to raise.

Did you have any problems with the new bearing wanting to go in cock eyed?

When is this going to be available?