Search results

Selling these new dss 2000hp half shafts. Will sell for 1050 shipped, minus 50 if local.

I have a set of 4 Weld S76B wheels for $2500 2 - 17x5 fronts with MT Sportsman S/R 26" front radials 2 - 17x10 rears with ET Street R with 305 45 17 rear drag radials I'm the second owner, the previous owner put very little miles on them, and I only ran these at the drag strip for a total of...

$350 Whipple oversized heat exchanger (new) - comes with additional hosing to connect to existing.

This is now SOLD Used UPR multi chamber catch can. Has a few scratches as seen in the photo 100 shipped in CONUS

Can you get these yet?

I'm looking for somebody to install a Circle D torque converter for a 6r80 trans. Any recommendations?

Has anyone tested whether an 18 intake manifold can be upgraded to a cobra jet or if an 18 intake manifold can be installed on a 15-17. I haven’t seen enough detailed pictures to form an opinion on whether this would work considering g all the changes on the 18 engine bay.

Looking for a Mach thunder center muffler section. Looking for a used one before I buy a new one.

I'm interested in picking up an euro decklid. The one with the raised circle with the GT logo inside.

So I've got the wheel hop and some Viking adjustable for the rear of the car, what are good options for the front. I see Viking is selling front coilover but they look pricy. What dampers are best for the strip?

Are the gt350 or gt350r tpms compatible with othe 15+ mustangs?

I setup a dyno day here in Atlanta after many of us had swapped intake manifolds. Here are the results. I'm sure many of the dyno racers out there will find this enlightening. All the runs were on the same day within a 3-4 hour window. The top run for each manifold were combined into 1 dyno...

Are you guys gonna put the install instructions on the new site?

While not for everyone, I replaced my fender badges with these Coyote Badges.

Livernois CAI made by Airaid $230 shipped CONUS OBO -No tune required -Missing one screw for the cover but can be obtained from Airaid -Can do local sale in Atlanta area as well.

I just installed the Scott Drake Heat Extractor Hood Inserts. Install is super easy, about 30 minutes. Photos are attached. UPDATED WITH INSTALLATION VIDEO FROM CJ PONY PARTS: [ame]

I've been toying with the idea of running true street when NMRA comes to Atlanta. I don't have a fast car but I think I might have a chance for the 12 index. Plus it'll give me a chance to get a time on an actually prepped track. Anybody else run this before and have thoughts or suggestions...

So looking at the install instructions for the Diff bushing inserts, what purpose do the replacement 14mmx65mm bolts serve. If I'm reading right you just remove the old one and replace with the new one. The other bolts replace the bolts for the differential bushing. I can't figure out these...