Search results

Was driving the other day and I hear a snap and felt the lumbar support in my driver seat completely collapse. Hitting the buttons I can hear it working, and there is some very minute movements, but its definitely gone. Anybody have this happen to them? Not sure if I should try to fix this...

I bought a complete set of MPSS last november and just recently had to replace the rears (fronts were still at 6/32). I didn't notate the mileage when I bought the initial set, but I drive roughly 1k miles a month, and pretty conservatively. Seems a bit low I think? I am lowered, but get an...

I'm looking to buy a can of spray paint of oxford white. I found one at autozone but the color was almost an offwhite instead of pure white despite being labeled "ford oxford white." Looking for a place that will match the paint code for my car.

I like the drop I have on my BC coilovers. It's raked with the front being lower than the rear. However because of this, my current tires (275/35/20) will rub if I try to straighten out the camber. Right now the best they can do is -3.0 up front before the tires will rub. With this much camber...

Was pulling my trunk apart for my car audio install and this piece came loose and dropped out after I pulled one of the rear panels on the interior of the trunk. Didn't see where it dropped from. Anybody knows where this goes/orientation?

I have an airaid intake and solo exhaust. Neither of which require a tune so I was planning on loading the stock tune and dynoing to have basically a base line (aside from the couple hp the airaid gives me). I then plan on installing a steeda Cai and e85 tune and dyno that configuration...

I bought a set of Forgestar F14's in 20x9.5 27mm all around. I rotated my tires the other day and when I switched the rear sets up front, the center caps popped off. The caps in the rear wheels are fine. Are there two different flush mount caps? The ones I have are here...

I'm thinking of going to an event at Thunderhill in april and they have a 103 db sound limit I believe. I have a Solo Performance Street Race exhaust on my GT and I'm a bit worried that I may get flagged for it. Hate to drop a few hundred dollars and get sent home. Any of you guys with louder...

I have the following equipment that I want to turn on when i turn on the car/ACC mode. I also want them to stay on after the engine has been cut, but the door hasn't been opened (like how the factory sound system is). Which fuse or wires should I tap for pin 30 (12V) and pin 85 (remote turn...

I have a bluetooth OBD scan toolthat I use with the Torque app on my phone. I also have a Lund Ngauge. While a bit redundant I wanted to use both at the same time, so I bought an OBD splitter to see if it was possible. Unfortunately if the bluetooth module is sending data to my phone, the Ngauge...

I removed the center console latch mechanism to make it easier to install my Redline goods armrest cover but and now I can't get it back to working order. There is a little tension clip that popped out as soon as I unscrewed the two screws holding down the latch mechanism. Can anyone help me...

I have the following that I hope to hook up to the factory nav unit (non-shaker system): Helix Blue B One Amplifier (950 watts x 1 at 1 ohm) Helix Blue B Two Amplifier (120 watts x 2 at 2 ohms) JBL P660C 6.5" Components FI Q 12" 2ohm DVC Subwoofer However I'm confused on what I need...

Wondering if the Steeda subframe braces can be installed with the BMR jacking rails.

That's pretty much what is keeping me from getting longtube headers. May have to cancel my gt350 intake manifold plans if that's the case. I know I wont have to smog for 5 years, but after that, you gotta smog every 2 years. Cold air intake is one thing, but swapping intake manifolds each time...

Looks like a good option for us jealous 2015 guys. http://www.cjponyparts.com/starkey-heat-extractor-led-turn-signal-kit-gt-2015/p/3660-V/ Will probably be cheaper then trying to retrofit the 2016 modules onto our 2015 cars. [ame]

Would it be worth getting the BMR CB005 cradle kit? I have an auto so wheel hop is already not as noticeable as on the manual stangs. Would they provide any worthwhile improvement? Or should I buy the CB005 and sell the Steeda subframe bushings?

I have a Magnaflow Street catback and I think I'm getting too used to the sound. Honestly I was surprised at how loud they were as everyone said they were barely louder than stock which is not the case at all. I do like the tone, but now I want something louder. Nothing crazy louder as I...

Looking for a car audio shop that has experience with our generation. I've gotten a wide gamut of prices but they all have no experience with our cars. Looking to install a processor, 2 amplifiers, a set of components and a subwoofer. I have all the parts already. Just need them to handle the...

I'm running 20x9.5 (27mm offset) wheels with a 275/35/20 tire and I'm pretty sure some of you guys run more aggressive setups. It looks like my back wheel wells are all chewed up, or is this normal?

Being the dummy at I am, I loosened my steeda strut tower bar to remove my engine cover, and while tightening it back up, I tightened one side before the other. The result, I screwed up the threads on the bolts that the strut tower bar goes on to as well as messing up the nuts from Steeda. How...